One Inch Compression Port Aluminum Bulkhead Feedthrough Adapter, Fits 1" Hole Through, up to 1.25" Thick.
These aluminum bulkhead adapter fittings are designed to fit through a 1 inch diameter hole and can be used on plates up to 1-1/4" thick. The fitting is sealed with a Viton O-ring. The compression port provides a quick vacuum connection for mounting gauges, instruments, or adding a tube port without welds. They are designed to work with round 1 inch outer diameter parts or tubing and are high vacuum rated down to the 10
-8 Torr range. Included is a 2-piece, 1 inch compression plug with Viton O-ring seal which can be used to blank off the port when not in use. The bulkhead nut and washer are made of brass.
NOTICE:
Brass alloys contain Zinc. Zinc will outgas from brass under certain combinations of elevated temperature and high-vacuum. System damage may occur if these conditions are present.
One Inch Aluminum Compression Port Bulkhead Adapter Data:
- Body Material: 6061-T6 Aluminum
- Nut and Washer Material: Brass
- Seal: Viton O-Ring
- Ultimate Vacuum: 10-8 Torr (High Vacuum)
- Fits 1.0 in. OD Plate Through Hole
- Maximum Plate Thickness: 1.25"
- Fitting Minimum ID: 0.76 in
- Compression Side Length = 2.0 in.
- Compression Side OD: 1.375 in. (not including plug)
- OAL: 4.50 in.
The bottom nut and washer are made of brass.
WARNING:
Brass alloys contain Zinc. Zinc will outgas from brass under certain combinations of elevated temperature and high-vacuum. System damage may occur if these conditions are present.
1 Inch Baseplate to 1 Inch Compression Port Fitting Adapter, Aluminum Feedthrough
Common Dimensions:
A = 0.76 Inches
B = 2.00 Inches
C = 1.375 Inches
D = 4.50 Inches
